LEDniceker 10-Meter Waterproof Flexible Color Changing RGB SMD5050 300 LEDs Light Strip Kit
Superbright 5050 SMD RGB LED, high strength as well as integrity
Water resistant flexible LED strip(IP65 Waterproof Level)
30 SMD RGB LEDs per meter, total 150 LEDs for 5 meters
Self-adhesive back with double side sticky tape
Maintenance cost-free, very easy setup
Every 3-LED cutable without damaging the remainder strip
Flexible bow for bending around bends
Ultra-bright but running at reduced temperature level
Input volts: DC 12V (12V 5A for 5meters 5050 300LED light strip)
Viewing Angle: 120 ° Long life expectancy 50,000+ hours
MiNi 44 Keys RGB Remote Controller:
Connection mode: Common Anode(+)
Input: 12V(Power Adapter/Supply Not Included)
Output: 12V 6A
Max tons current: 2A each shade
Mode & Pattern:
8 Light Pattern: Quick/ Slow/ Auto/ Flash/ 7 shade fade change/ 3 shade fade change/ 7 shade jumpy change/ 3 shade jumpy change R/ G/ B boost as well as decrease control
6 DIY keys
44 keys infrared controller which has 6 keys(DIY keys) for momories the colors what you preferred.
Control variety: 10cm - 500cm RGB LED Strips
Support 5 meters SMD 5050 30LEDs/M LED Strips or 5 meters SMD 5050/3528 60LEDs/ M LED Strips
12V5A Power Supply Adapter ?
Type: 12V 5A
Input: 100-240V Air Conditioner 50/60Hz
Out put: 12V 5.0 A
Plan consisted of:
2 x 5 meter/1 roll led strip
1 X MiNi IR Controller
1 x 44 Key Remote Controller(Battery Included)
1 x 12V 5A Power Supply
Easy Installation & Use: Led strip light can be cut between every 3 leds. self-adhesive tape can be fit on any dry and flat surface. Lifespan is over 50000 hrs. Save effort and cost.
Multi-color Strip Lights with 300 waterproof 5050 RGB SMD LEDs in 32.8ft with dimming and brightness controls, suitable for indoor outdoor lighting and décor. Such as kitchen, under cabinet, dining room, bedroom, garden, patio, balcony, party, wedding etc.
Waterproof. IP65. Please note: only LED strips are waterproof. Remote controller, power adaptor and connectors are non-waterproof.
All in one kit. RGB LED strips, remote controller, power adaptor and connectors are included. No more accessories are required.
Remarks: If the power adapter or other accessories do not work, please contact us for a free replacement. Connect the load and power lines, make sure all connection right before power switched on; Insure there is no obstacle between the IR controller and the receiver when operating; Take off the plastic sheet of remotes battery before using.